ListlessSpectre's Product Reviews
Sort:

Avatar
ListlessSpectre
Verified

VERIFIED OWNER
  • JoinedJan 2014
  • Posts 525
  • Reviews 107
  • Kudos193
Overall   (5.0)
› Quality
› Value
PROS
*Looks perfect on the GPaps *Good vape, nice dense clouds *Hybrid mode *Has potential for fat coils
CONS
*Rather small airhole, but not bad *Have to rebuild it to keep the drip tip from hitting the post, but is easily do-able
Personally, I like this setup a lot. May be my main mod for a while. My setup for my review was 24g Kanthal wrapped 8 times @ .3 ohms. If you put the airhole right behind the coil, you'll get some dense, tasty clouds off of it. Even w/o drilling. If you have the mod for it, I would highly reccomend. [IMG]http://i693.photobucket.com/albums/vv297/metalcraft54/junk%20drawer/14-1_zpsed445a68.jpg[/IMG]
Reviewed on
Pre-made Welded Wires - NR-R-NR (100-Pack)
Pre-made Welded Wires - NR-R-NR (100-Pack)

Avatar
ListlessSpectre
Verified

VERIFIED OWNER
  • JoinedJan 2014
  • Posts 525
  • Reviews 107
  • Kudos193
Overall   (4.2)
› Quality
› Value
PROS
Gets the job done.
CONS
Scary short!
I just had these come in earlier to add to the 2.2ohm wires I use for my Ithaka, and lemme tell ya, these are a very, very close fit. No wiggle room at all. The NR wire legs are almost too short for my application without a very steady hand and a good set of curved tweezers to get them into place.
Reviewed on

Avatar
ListlessSpectre
Verified

VERIFIED OWNER
  • JoinedJan 2014
  • Posts 525
  • Reviews 107
  • Kudos193
Overall   (5.0)
› Quality
› Value
PROS
nice look
CONS
none (yet)
looks good on the brass Tobh with which I bought it for.
Reviewed on

Avatar
ListlessSpectre
Verified

VERIFIED OWNER
  • JoinedJan 2014
  • Posts 525
  • Reviews 107
  • Kudos193
Overall   (5.0)
› Quality
› Value
PROS
Gorgeous 3 holes on each side Copper contact Moderately deep wells on the deck Fits 24 gauge wire with the ease Doesn't mind obscenely low ohm bills
CONS
if you're into big coils this isn't your RDA
dropped this on to a satin brass King v2 with a brass Pyrex glass dropped it and it is a gorgeous set up. A beautiful compliment to any brushed brass mod. Also, needed no customization. Good density and flavor right out of the box. If you don't have one of these, get one.
Reviewed on

Avatar
ListlessSpectre
Verified

VERIFIED OWNER
  • JoinedJan 2014
  • Posts 525
  • Reviews 107
  • Kudos193
Overall   (5.0)
› Quality
› Value
PROS
*Finish is gorgeous and flawless *Engravings are deep and detailed *NO machine oil...none *Switch is very short throw and buttery smooth *20:1 threads..compatible with many hybrid attachments
CONS
Not a single one...believe it or not
I have a ceramic coated HCigar Kayfun 3.1 ES attached to this mod and they are absolutely perfect with each other. I also have the #IMPROOF satin brass King V2 as well and for as much as I loved it, it got kicked to the curb for this one. Definitively the best in my collection now.
Reviewed on